Prikolica z nizko platformo

FLIEGL VTS 400 S Luft/ Hydr. 4-Achs Tieflader -903

New Fliegl 4-Axle Low Loader Trailer with Ramps, Type VTS 400

Gross vehicle weight: 24,000 kg / 40,000 kg
Unladen weight: 8,080 kg
Payload: 15,920 kg / 31,920 kg
Overall length: 11,940 mm
Loading length: total approx. 10,410 mm, gooseneck approx. 2,490 mm, loading deck incl. rear slope approx. 7,920 mm
Width: 2,550 mm
Loading height: 900 mm
Further information:
Plus transportation and provision ex stock 26639 Wiesmoor €1,280 / net

Chassis Low Loader Trailer
Steel welded construction
Turntable with heavy-duty slewing ring
Foldable rear supports
2 wheel chocks with holders
Aluminium side underrun protection
Rear spray flap across the full width
Half-shell mudguards on 1st and 2nd axles with anti-spray flaps behind each axle,
Anti-spray flaps in front of and behind 3rd and 4th axle
Excavator arm trough over the rear axles extending to the rear, approx. 1,800 mm long, approx. 650 mm wide and approx. 150 mm deep,
2 pairs of lashing holes, each 5 t, in the excavator arm trough on the side of the longitudinal frame, approx. 300 mm from the front and approx. 200 mm from the rear ramp
1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable
Storage compartment embedded in the floor of the gooseneck with lid, W=720 mm / L=520 mm / D=170 mm
Extendable widenings up to 3,000 mm (not in rear slope)
(Track width of construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks below the platform
70 mm wooden planks for widening to 3,000 mm
Lashing points low loader
1 pair of lashing cut-outs in the longitudinal beam at the front of the gooseneck, each 10 t
4 pairs of lashing holes in the outer frame, each 5 t (for lashing strap hooks)
9 pairs of lashing mushrooms mounted on top and side of outer frame, each 10 t
2 x at the front on gooseneck
7 x on the low-bed deck
First lashing ring 250 mm from front and last max. 250 mm from rear, spacing between lashing rings not more than 1,100 mm
Additional 3 pairs of folding lashing rings, each 10 t
1 x on gooseneck (protruding)
1 x at the start of the low-bed deck embedded in the longitudinal beams
1 x behind the last axle embedded in the floor
Drawbar coupling for turntable trailer
Drawbar with tested 50 mm towing eye
Drawbar height adjustment via spring
Axles + suspension
Drum brake axles, manufacturer’s choice
Pgsdpfxsxrx I Uo Af Neu
"Axle/chassis laser alignment" reduces tyre wear and fuel consumption
Air suspension with raise & lower valve + auto-reset function
Wheels and tyres
235 / 75 R 17.5"
manufacturer’s choice
Steel rims in twin configuration, factory silver
Brake system
2-line compressed air brake system
Spring-loaded parking brake
Axle load detection via EBS-CAN bus signal, for display in driver’s cab, truck must be prepared accordingly, no truck installation (not a calibrated scale)
Vehicle stability control system
2 fool-proof coupling heads at the front with connection lines to the tractor unit,
12-24 Volt EBS, electronic braking system with EBS plug at the front, with connecting cable
Brand: Knorr
Important: The trailer may only be towed by towing vehicles that ensure ABS operation!
Electrics
12-24 Volts, multi-chamber LED lights, yellow LED side marker lights, LED license plate lighting (Note: some towing vehicles may display error messages, even though function is OK)
2 white LED position lights at the front
2 white/red LED lane positioning lights at the rear
2 x 7-pin fool-proof plugs at the front, with connecting cable
1 LED beacon with

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.