Prikolica z nizko platformo

MÜLLER-MITTELTAL 3-Achs Plateau, luftgefedert, hydr. Rampen

Stanje: novo, največja dovoljena obremenitev: 23.500 kg, skupna masa: 30.000 kg, konfiguracija osi: 3 osi, dolžina tovornega prostora: 8.380 mm, širina tovornega prostora: 2.520 mm, Leto izdelave: 2026, * PT 30 Profile: * EBS (Electronic Braking System) * Emergency release device for spring-loaded cylinders * Drum brakes * 3 x 11 t Gigant axles * Air suspension with lift and lower system and RtR-valve * Smart Board installed on trailer as information tool (axle load display - separate for front and rear) * Tire pressure monitoring with display option in the truck via EBS signal without truck-side installation * Side underrun protection * Swivel supports at rear of chassis frame * Mechanically adjustable warning sign packages at front and rear * Front axle: plastic quarter mudguards with spray protection * Rear axle: straight galvanized steel skirts with spray protection * Contour tape on sides and rear, reflective * 15-pin power plug * LED lighting 12 / 24 V * LED beacon (removable) at rear * Drawbar 1,200 mm long with 40 mm towing eye and height adjustment via draw spring & turnbuckle * Toolbox made of galvanized steel approx. 650 x 300 x 600 mm, black powder coated, side right * Compartment in rotary frame for accessories with folding lid, 2 pcs. container locks permanently installed (directly after turntable platform) * ROBOT welded anti-slip coating on the steel plate of the rotary frame platform (protruding weld seams) * Load securing package consisting of: 2 lashing rings (13.4 t) at front left & right on front wall bearer, front & rear 1 pair of UVV lashing rings (13.4 t), and on each side 3 pairs of UVV lashing rings (10 t) pivotable and lowerable, loadable in all directions and embedded in the outer frame, each side with 3 stake pockets with simultaneous 2 t lashing option * 6 pairs mechanical folding outriggers for 3 m total width (not in the rear taper) * Extension boards stored in the middle of the loading area * Hydraulic one-piece drive-on ramps approx. 3,000 x 720 mm * Mechanically laterally adjustable * 4-way control block for later retrofitting of hydraulic ramp shift * Excavator arm storage over rear axle, continuous to end crossmember (total length approx. 2,100 mm) * 2 pairs of lashing rings LC 6400 daN in excavator arm storage at side in longitudinal frame * 2 steps galvanized at rotary frame left + right * Profifix lashing strip centered in longitudinal axis, in flat area for lashing up to LC 3000 daN Csdpfxetplwie Abvspw * Chassis, turntable, folding outriggers, drop supports, and drive-on ramps hot-dip galvanized * Axles, slewing ring, air tank, tow bar painted in black tone * Loading edge loaded approx. 910 mm +/- 20 mm air suspension * New vehicle with manufacturer warranty * Errors and intermediate sale excepted * Available approx. from week 22/2026 * Sample images

Stanje: novo, Funkcionalnost: popolnoma funkcionalen, lastna masa: 7.500 kg, največja dovoljena obremenitev: 36.500 kg, skupna masa: 44.000 kg, konfiguracija osi: 3 osi, dolžina tovornega prostora: 9.190 mm, širina tovornega prostora: 2.540 mm, višina nakladalnega prostora: 900 mm, vzmetenje: jeklo-zrak, velikost pnevmatike: 235×75 R17,5, medosna razdalja: 1.310 mm, Leto izdelave: 2024, Oprema: ABS, osrednja vrtljiva plošča, CETRATEK 4-Axle Low-Loader TL89.4 (EU-COC) Short Description Robust low-loader for heavy machinery transport. Frame made of high-strength ST-52/S355 steel, optionally with fine-grained steel S700. Ramps rated at 20 t load capacity each, mechanically or hydraulically foldable without loss of carrying capacity. Optionally available as a low-bed version; loading height in the wheel recess area can be reduced from approximately 900 mm to around 500 mm. Dimensions / Construction Total length: 11,914 mm, Maximum height: 3,775 mm (over ramps) Platform: Gooseneck 2,440 mm + Deck 6,750 mm Width: 2,540 mm (manually extendable by 250 mm each side) Fifth wheel → 1st axle: 2,767 mm, → 2nd/3rd axle: 6,136 mm Axle distances: front 1,310 mm, rear 1,360 mm Deck height: 900 mm (low-bed ~500 mm), Track width: 1,850 mm Rear ramps: 3,000 × 750 mm, laterally adjustable, 20 t per ramp Drawbar eye height: 400–900 mm; Turntable Ø 110 (CYR) Floor: Steel + 45 mm beech hardwood, protective lacquered Weight / Capacity a) GVW 44,000 kg → Payload ~36,500 kg* b) On-road 24,000 kg → Payload ~16,500 kg * Version a) requires special approval (§70 StVZO); inspection/DEKRA certification at additional cost. Drawbar eye Ø 50 mm (optional Ø 40 mm), unladen weight approx. 7,500 kg Rear supports: manual (hydraulic optional) Steel Structure / Chassis Welder qualification: TS EN ISO 9606-1, processes TS EN ISO 4063, shielding gases TS EN ISO 14175 4 × 11 t axles (TRAX), tyres: 235/75 R17.5 (16 pcs., PETLAS or equivalent; Continental/Michelin optional at extra cost), rims: 6.75×17.5, air suspension, permitted up to 100 km/h Brakes / Electrics WABCO EBS 4S/2M, linings: 330×200, air tanks: 2×80 L + 1×60 L Brake cylinders: 4× Type 24 + 4× Type 24/30, levers: 165 mm Cedpeu Rbzvjfx Abvjpw Voltage: 24 V (if towed by 12 V vehicle, possibly requires voltage converter) Side reflectors: 4× LED per side + 2× white front reflectors, rear lights: 2× LED, 2× triangular reflectors Connections: 7-pin EBS ISO 7638, 7-pin ISO 1185/3731, 15-pin ISO 12098 Note for tractor operation: 12→24 V transformer as well as ABS/EBS connection (ISO 7638) and power supply (e.g., ISO 1185/12098) required for the vehicle’s onboard hydraulics. Hydraulics (Ramps) 2 cylinders including changeover valve for operation via tractor’s onboard hydraulic system Accessories (Excerpt) 2 toolboxes, 2 wheel chocks (metal), fire extinguisher compartment Reflectors (side: white/yellow; extendable: yellow/red), rectangular rear reflectors Lashing rings: 7 per side + 6 on deck (10 t/ring) Mudguards (front/rear), hose/cable holders on the drawbar Coating System Sandblasted, 3× epoxy primer, 3× acrylic (≈ 230 µm), 1× acrylic clear coat Warranty 2 years on frame structure and axles (excluding accidents/operator error) 2 years on electrical system & brake system (except wear parts such as brake linings, accidents/operator error) 1 year on paintwork (excluding accidents/operator error) Technical and price changes reserved. Images are for reference only and may include optional equipment.

Stanje: rabljeno, Leto izdelave: 2012, obratovalne ure: 2.174 h, Contact Geert Geuens for further information. Cedjx Th Hfepfx Abvopw

Stanje: rabljeno, največja dovoljena obremenitev: 15.860 kg, skupna masa: 21.000 kg, konfiguracija osi: 2 osi, prva registracija: 09/2024, naslednji pregled (TÜV): 06/2026, dolžina tovornega prostora: 4.995 mm, širina tovornega prostora: 2.380 mm, višina nakladalnega prostora: 1.000 mm, * KA-TA-R 21.0: * Wabco EBS (electronic braking system with RSS) * Emergency release device for spring brake cylinders * Drum brakes * Gigant axles Cjdpfx Asv D Tb Rjbvepw * Air suspension with level control during tipping operation * Start-up aid for maneuvering purposes on the 1st axle (controlled via EBS) * 1st axle as a lift axle (fully automatic) * Jost landing gear at the front * EBS multi-voltage system for towing vehicles with 12 & 24V electrics * 7-pin 12V power connector * Multi-chamber tail lights with galvanized protective box * 2 LED reverse lights * One LED work light per side * Drawbar with K80 ball coupling (adjustable mm, coupling height approx. 440 - 550 mm when loaded) with elevated conduit support for connection lines * Bolted galvanized steel underrun protection * Plastic quarter mudguards in front of the first and behind the last axle * Shovel and broom holder on the front cross member * Chassis made of high-tensile steel * Steel 3-way tipping body (fixed front wall, continuous side walls - without center sections -, right side wall swinging via central locking and foldable with drop side torsion spring lift, left side wall foldable with hydraulic drop side, tailgate swinging via automatic hook lock, 5 mm steel floor made of HARDOX-450 or equivalent, 4 x 3 t. UVV lashing rings recessed per side in the outer frame) * Support load 3 t. * Tyres 600/55/R22.5 * Errors and prior sale excepted * Trailer is in a very good / as-new overall condition