Priklopnik z delovno ploščadjo

MÜLLER-MITTELTAL PT40 Sonderpreis, Tieflader mit hydr. Rampen

Stanje: novo, največja dovoljena obremenitev: 31.000 kg, skupna masa: 40.000 kg, konfiguracija osi: 3 osi, dolžina tovornega prostora: 9.290 mm, širina tovornega prostora: 2.520 mm, višina nakladalnega prostora: 950 mm, * PT 40.0 profile: * Wabco EBS-E (electronic braking system) * Emergency release mechanism for spring brake cylinders * Drum brakes Itodpfx Asl Tnu Asb Usr * 4 x 11 t Gigant axles * Air suspension with lift and lowering function as well as return-to-ride valve * Pressure gauge for axle load determination (axles separated into 2 air suspension circuits) * Side underrun protection * Swing-out supports at the rear of the chassis frame * Mechanically adjustable warning panels front and rear * Front axle: plastic quarter mudguards with spray guards * Rear axle: straight, galvanized steel side skirts with spray guards * Reflective contour marking tape, side and rear * EBS multi-voltage system with 12 & 24 V electrics * 15-pin power connector * LED lighting system 12 / 24 V * Removable rear LED beacon * 2 LED reverse lights (controlled by reverse gear) * Drawbar with 50 mm towing eye and height adjustment * Tool box made of galvanized sheet steel, black powder coated, approx. 1,000 mm wide, 600 mm deep, 300 mm high * Front section ahead of turntable platform approx. 490 mm long with 45° corners * ROBOT-welded anti-slip coating on the steel plate of the turntable platform * Load securing package consisting of: 1 x 13.4 t UVV lashing eye left & right in front of front bulkhead support, 4 holes per side in the turntable platform for 2 t lashing capacity each, 1 pair of lashing eyes (13.4 t) hanging at the rear left & right in front of the end support, 4 pairs per side of UVV lashing rings (10 t) that can be swivelled and lowered, loadable in all directions and recessed in the outer frame, 3 stake pockets per side with simultaneous 2 t lashing possibility * Hot-dip galvanized mechanical fold-out outriggers for 3 m overall width (not in the rear slope) * Plank holder for extensions mounted longitudinally under the chassis on the left * Excavator arm rest over the rear axle up to the end cross member, approx. 2,100 mm long and approx. 190 mm deep, with 2 pairs per side of 6.4 t lashing eyes in the excavator arm rest * Hardwood floor on the running surfaces of the low bed platform * Hydraulically operated one-piece loading ramps (approx. 3,000 x 720 mm), mechanically adjustable sideways * Outer boards of the loading ramps made of hardwood * Steel construction prepared for 6-valve control block * Loading edge unladen approx. 950 mm +/- 20 mm chassis * Turntable, fold-out outriggers, mechanical drop supports, loading ramps hot-dip galvanized * --Axles, air tanks, and drawbar painted in black shade-- * Tires 235/75 R 17.5 * The vehicle has a day registration from 07/2024, due to the lack of a tire pressure monitoring system, and has not been loaded or used * New vehicle with manufacturer's warranty * Subject to errors and prior sale * Immediately available ex Egestorf