Nizki nakladalnik

Fliegl ZTS 200 P

Further information

Chassis Low-bed Trailer
Steel welded construction
Turntable with robust ball bearing slewing ring, storage box integrated into turntable front section
Foldable rear support
Wheel chocks with holders
Aluminum side underrun protection
Half-shell mudguards on 1st axle, quarter-shell mudguards in front of and behind the 2nd axle
with anti-spray flaps behind each axle
Tedpfx Aei Ri N Hoh Eod
1 plastic toolbox with shelf, w=620/h=360/d=440 mm, lockable with a padlock (lock not included)
Extendable widening to 3,000 mm (not in rear taper)
(Track width of construction machines or vehicles to be transported must not exceed 2,550 mm external frame width), storage compartment for wood planks centered in the loading area, 70 mm planks for widening to 3,000 mm,
Tie-down eyes low-bed
3 pairs of lashing points integrated in the floor at the front, each rated for 10 t
6 pairs of lashing mushrooms recessed in the top and sides of the external frame, each rated for 10 t
1x after neck area, rest distributed in between, spacing not greater than 1,200 mm
1x rear taper
5 pairs of ring lashing eyes recessed in external frame, each rated for 5 t (instead of stake pockets)
Trailer turntable drawbar
Drawbar with tested 40 mm towing eye
Axles & Suspension
SAF drum brake axles
Axles/chassis laser-aligned to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings
Wheels and Tires
235 / 75 R 17.5
manufacturer's choice
Twin steel rims, factory silver
Braking System
2-line air brake system
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connecting lines to the tractor unit,
ABS and ALB, with ABS connector at the front, with connecting cable
Attention: The trailer must only be towed by towing vehicles that ensure the effectiveness of ABS!

Electric system
24 Volt, multi-chamber lights, yellow LED side marker lights
2 white/red width marker lights at rear
2 white position lights at front
1 rotating beacon with bracket, switchable via parking lights (removable beacon)
2 pairs of warning boards, double LED illuminated and extendable to 3,000 mm
2 x 7-pin fail-safe connectors at the front, with connecting cable

Floor
Front area steel floor,
then 70 mm softwood floor, wheel arch area with steel/tread plate covering
Rear taper with 70 mm softwood floor
Low-bed area incl. rear taper 8,200 mm

Access Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Additional ramp safety below, foldable (prevents lateral slipping, not in conjunction with hydraulic side shift)
wooden planking
with spring assist

Operational Notes
A special permit is required for an axle load of 10,000 kg. The permit must be applied for individually in each federal state, and the legislator is not obliged to grant approval for a 20 t gross vehicle weight. Customer's risk.
The specified gross weight is technically possible, depending on the cargo the gross weight may not be achievable while observing the permitted axle, support, and kingpin loads.

Registration / Plates
Registration country: Germany
EC type approval acc. to 2007/46
24/7 service hotline
Prepared for two-line number plate holder
Contour marking with reflective strips in accordance with ECE R 048, white at the sides and red at the rear
Warning sign according to ECE - 70

Paintwork
Frame DB Nova grey
Access ramps hot-dip galvanized

Note: Archive images!

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.