Odprta platforma

Fliegl SZS 310 Jumbo Plateau Holz

Further Information

Chassis: Semi-Trailer for Freight Forwarding
Fine-grained steel welded construction, fifth wheel plate with interchangeable king pin, two king pin positions.
Outer frame slightly sloped with load-lock profile for attaching lashing straps. Note: When using lashing straps in conjunction with side boards, the side boards must be opened to attach the straps!
2 pairs of lashing rings recessed into the outer frame on the gooseneck, each rated at 5 tons
8 pairs of lashing rings recessed into the outer frame in the low bed, each rated at 5 tons
24-ton two-speed landing gear, single-sided operation, with straight lower section, without sliding compensation
2 wheel chocks with holders
Aluminum side underrun protection
Steel rear underrun protection
Quarter shell mudguards in front of and behind the axle assembly
2 stainless steel toolboxes, width=600/height=400/depth=500 mm, with polished lockable door
2 pairs of stake pockets recessed into the outer frame on the gooseneck, internal dimensions 70 x 40 mm
6 pairs of stake pockets recessed into the outer frame in the low bed, internal dimensions 70 x 40 mm
!!Internal width between stakes: 2,420 mm!!
3 lashing/stake rails in the low bed, recessed crosswise into the floor across the entire width up to the outer frame (max. usable internal width between external drop-in stakes approx. 2,170 mm), approx. 100 mm high. With 20 mm round bar rails, top and bottom, approx. 60 mm clearance between the round bars (top to bottom). Bottom finished with angle plate, half open to below. For lashing and setting stakes 80 x 80 mm.
Quantity: Drop-in stakes B=80/T=50/L=1200 mm, hot-dip galvanized
Quantity: Drop-in stakes B=80/T=80/L=1200 mm, hot-dip galvanized
Note: Stake pockets / drop-in stakes are not intended as the sole means of load securing for long materials, pipes, etc. without lashing.
Rear extension manual with hand crank, extendable approx. 1,500 mm, lockable every 500 mm, with support beam; load capacity at center of gravity: approx. 2,000 kg over entire width at 500 mm, 1,000 kg at 1,000 mm, 500 kg at 1,500 mm; includes extendable rear underrun guard with lighting.
2 pairs of drop-in stakes B=80/T=80/L=1200 mm, hot-dip galvanized
Open storage compartment for drop-in stakes at the front wall or below the load area (for 10 drop-in stakes 80 x 50 x 1200 mm and 4 stakes 80 x 80 x 1200 mm)
Axles & Suspension
SAF drum brake axles
Axles/chassis laser aligned, reduces tire wear and fuel consumption
Last axle is steering, with automatic reverse lock via reverse light and additional manual lock on the vehicle via a hand button.
Air suspension with raise & lower valve
Wheels and Tires
235 / 75 R 17.5
Manufacturer’s choice
Steel twin rims, factory silver
Braking System
2-line compressed air brake system
Spring-actuated parking brake
2 foolproof coupling heads at front, without connecting line
EBS, Electronic Braking System with EBS socket at front, no connection cable
Attention: The trailer may only be towed by vehicles that ensure ABS effectiveness!
Axle load detection via EBS CAN bus signal, for display in driver’s cab; truck must be properly equipped, no truck installation (not a calibrated scale)
Electrics
Itodpei Ri Hvofx Ab Hjd
24 volt, multi-chamber lights, side yellow LED lighting
2 white position lights at front
2 white/red lane marker lights at rear
2 x 7-pin sockets at front, without connecting cables
2 additional LED work lights at rear, switched via reverse light
1 LED rotating beacon with bracket, switch

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.