Tristrani nagibni priklopnik

FLIEGL TSK 118 Tandem Dreiseitenkipper 5,0m Kipp Anhäng

Further information

plus pre-carriage / provision ex storage location 26639 Wiesmoor €1,280.00 / net

Chassis: Central axle tipper trailer
Steel welded construction, continuous tipping shaft at rear with 80 mm ball bearing mount
Gear support leg at the front
Foldable rear support
2 wheel chocks with holders
Steel underride protection
Rear mudflaps across the entire width (not in combination with forklift holder)
Quarter-shell mudguards
1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable (lock not included)
Note! Sideboard contacts the toolbox when folded down.
Lockable storage compartment for loading ramps under the loading area
Central axle trailer drawbar
Drawbar with certified 40 mm drawbar eye
Height-adjustable drawbar via spindle, max. adjustment range 300 mm
Lsdoy Dzlijpfx Aibsrk
Axles & Suspension
GFA or BPW axles (manufacturer’s choice), with tapered roller bearings and S-cam brakes
"Axle/chassis laser alignment" reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load compensation (rocker compensation)
Wheels and Tires
235/75 R 17.5"
manufacturer’s choice
Steel rims, factory silver
Braking system
2-line compressed air brake system
Color-coded piping for easy service
Hand spindle parking brake
24 volt ABS and ALB, front with ABS connector and connecting cable
Attention: The trailer may only be towed by towing vehicles that ensure ABS functionality!
2 non-swappable coupling heads at the front, with connecting lines to the towing vehicle
Electrics
12 to 24 volts, multi-chamber LED lights, side amber LED lighting, LED license plate lights (Note: certain towing vehicles may cause false diagnostic errors, despite proper function)
2 white position lights at the front
2 white/red lane guidance lights at the rear
2 x 7-pin non-swappable connectors at the front, with connecting cable
1 additional LED work light at the rear, controlled via reversing light
Hydraulics
Three-way tipper system, hydraulic multi-piston press with lift limiter and safety cable,
Low-pressure cylinder up to max. 170 bar, without throttle. If required, this must be retrofitted on the truck (truck with max. hydraulic delivery rate of 55 l/min).
Hydraulic connection with SVK plug NW 10/3, including connecting hose
Operation hydraulically via truck PTO
Tipper body
Robust tipper body with 4 mm steel floor, steel sideboard structure, continuous side panels, foldable and swinging with central locking at the bottom. Rear corner posts plug-in. Rear panel foldable and swinging, with central locking at the bottom.
Bed length approx. 5,000 mm, sidewalls with 6 lower hinges.
Sideboard retraction springs (not possible with foldable front panel)
Bed width 2,420 mm
3 pairs of lashing rings in the floor, each 5 tons
Operating instructions
The specified total weight is technically possible; depending on the load, the total weight may not be achievable within the permissible axle/support/kingpin loads. (Poor driving and trailing behavior possible due to incorrect load distribution)
Country of registration / plates
Country of registration: Germany
with Dekra inspection and certificate (according to §13 EC-FGV)
24/7 Service hotline
prepared for single-line license plate holder
Contour marking with reflective strips according to ECE R 048, white on the sides and red at the rear
Coating
Frame hot-dip galvanized, including passivation
"15 years warranty against rust-through"
Sideboard/platform RAL 9010 pure white
Note!

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.