Nizki nakladalnik

Fliegl DTL-S 300 Agrar

Further Information
Chassis Low-bed Trailer
Steel welded construction
Turntable with heavy-duty ball race ring
Rear supports, foldable
2 wheel chocks with holders
Full-width rear mudflap
1 plastic toolbox with removable shelf, dimensions: W=620/H=360/D=440 mm, lockable with a padlock (padlock not included)
Prepared for extension to 3,000 mm width (holes in the outer frame, not in the rear beavertail)
Bjdex A Amcjpfx Abmsdk
Lashing points low loader
1 pair of tie-down recesses in the front longitudinal beams at the cranked section, each rated for 10 tonnes
7 pairs of lashing mushrooms recessed on top and side of the outer frame, each rated for 10 tonnes
- 1 x at the front crank
- 5 x in the low-bed section
- 1 x in the rear beavertail
12 pairs of lashing holes in the outer frame, each rated for 5 tonnes (for attaching lashing straps)
- 5 x at the cranked section, 6 x in the low-bed, 1 x in the rear beavertail
Drawbar arrangement for turntable trailer
Drawbar with tested 40 mm towing eye
Axles & Suspension
Drum brake axles, manufacturer’s choice
"Axles/chassis laser aligned" – reduces tyre wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load compensation (rocker balance)
Wheels and Tyres
235 / 75 R 17.5"
as per manufacturer's choice
Steel twin wheels, factory silver
Braking System
2-line air braking system
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front with connecting lines to the towing vehicle, connection lines extended by approx. 60 cm
Without ABS, but with mechanical ALB, thus max. 60 km/h approval
Electrics
12 Volt, multi-chamber lights, without amber LED side lights, with side reflectors
2 white front position lights
2 white/red lane marker lights at rear
1 x 7-pin 12 Volt plug at the front with connecting cable, extended by approx. 60 cm
1 LED beacon with bracket, switched via parking lights (light removable)
Floor
Front crank section with steel/chequer plate flooring
Stowage box recessed in the approach slope to the crank
Then 70 mm softwood flooring, wheel arch area with steel/chequer plate covering
Rear beavertail with 70 mm softwood floor
Low-bed loading area incl. rear beavertail: 5900 mm
Access Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Timber overlay
Spring-assisted
Operating Instructions
Axle loads exceeding 10,000 kg require a special permit, only for indivisible loads!
The specified gross weight is technically feasible; depending on the type of cargo, the gross weight may not be achievable within permitted axle, support, and kingpin loads. (Poor driving and tracking characteristics may result from incorrect load distribution)
Country of Registration/Plates
Country of registration: Germany
With Dekra inspection and report for max. 60 km/h approval, towing vehicle LoF (Switzerland max. 40 km/h possible)
Prepared for two-line number plate holder
Without contour marking / reflective tape to ECE R 048
Paint/Coating
Frame: Hot-dip galvanised including passivation, "15 years anti-corrosion warranty"
Drawbar: Galvanised or black finish, at manufacturer’s discretion
Access ramps: Hot-dip galvanised

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.