Priklopnik z delovno ploščadjo

MÜLLER-MITTELTAL T4 Radmulden / luftgefedert

* T4 RM 40.0:
* Wabco EBS-E (electronic braking system)
* Emergency release device for spring-loaded cylinders
* Tire pressure monitoring with display capability in the truck via EBS signal - no on-truck installation required
* Drum brakes
* 4 x 11 t Gigant axles
* Air suspension with manual lowering at the rear
* Warning sign packages front & rear
* SmartBord infotool mounted with pressure sensors for total axle load display per axle group
* Reflective contour tape on the sides and rear
* Removable LED beacon at the rear
* 15-pin power connector
* LED tail lights
Fedpfjxmpydex Affopn
* Straight drawbar with 50 mm towing eye and stepless height adjustment
* Front closed individual plastic mudguards
* Rear straight steel mud flaps each with spray suppression
* Lateral underrun protection
* Front section ahead of the turntable platform extended approx. 520 mm with 45° corners and 3 storage compartments incl. lockable folding lids (folding lids open to the rear)
* Chassis made of high-strength fine-grained steel
* Floor over the turntable platform made of 50 mm and in the low-bed platform made of 60 mm softwood
* Outer planks of the loading ramps made of 50 mm hardwood
* Load securing package consisting of: 2 lashing rings 6.4 t front left and right on the main frame of the turntable platform, 1 pair of 13.4 t lashing rings per side at the front and rear on the outer frame, plus 1 pair of 10 t lashing rings per side swivel- and lowerable, loadable in all directions and recessed in the outer frame, bolted 5 t lashing rings to the outer frames of wheel recesses (2 for the front and 1 for the rear wheel recess), 2 pairs of 6.4 t lashing rings at the side in the excavator arm recess
* 11 pairs of folding outriggers for 3 m overall width (not at the rear slope)
* Storage compartment (L = 2,470 x W = 570 x H = 250 mm) for the extension boards made of sheet steel, mounted across the loading area in front of the 1st rear axle
* Excavator arm trough above the rear axle to the end of the approach slope approx. 2,300 x 740 x 190 mm
* 2 wheel recesses per side, approx. 640 mm wide - front 340 mm deep, rear 220 mm deep - with retractable cover (storage for covers at the front of the turntable platform) for transporting wheel loaders with a wheelbase of 3,100 - 3,640 mm
* Mechanical drop-down supports at the rear
* Hydraulic folding ramps with hydraulically extendable tip part approx. 4,650 x 720 mm
* Hydraulic lateral ramp shift
* Load platform above the turntable: approx. 2,990 x 2,520 mm
* Rear loading area: approx. 6,780 x 2,520 mm, loaded platform height approx. 890 mm +/- 20 mm (incl. 860 mm approach slope)
* Chassis, turntable, folding outriggers, rear drop-down supports and loading ramps hot-dip galvanized
* Axles, air tanks, and drawbar painted in black
* Tires: 235/75R17.5
* Vehicle is hot-dip galvanized
* New vehicle with manufacturer warranty
* Errors and prior sale excepted
* Available from CW 14/2026
* Sample images

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.