Prikolica z nizko platformo

FLIEGL DTL 300 Agrar Greenlight Hydraul. 3-Achs Tieflad

Total weight: 24,000kg / 30,000kg
Curb weight: 5,600kg
Payload: 18,400kg / 24,400kg
Overall length: 10,290mm
Loading length: 5,900mm incl. rear bevel
Width: 2,520mm
Loading height: 860mm

Additional information:

Plus pre-carriage / handling from storage location 26639 Wiesmoor: €1,280.00 net

Chassis: Low-bed trailer
Steel welded construction
Turntable with heavy-duty ball race bearing
Folding rear support
Wheel chocks with holder
Rear mudflaps across full width
1 plastic toolbox
Preparation for widening to 3,000 mm (holes in outer frame with covers, not in rear bevel)
Lashing rings for low-bed trailer
1 pair of lashing openings in the front beam on the cranked section, each rated 10 t
7 pairs of lashing pins recessed in the top and side of the outer frame, each rated 10 t
1 x in front on the cranked section
5 x in the low-bed section
1 x in the rear bevel
12 pairs of lashing holes in the outer frame, each rated 5 t (for securing straps)
5 x cranked section, 6 x low-bed, 1 x rear bevel

Drawbar coupling (for turntable trailer)
Drawbar with tested 40 mm towing eye
Height adjustment of drawbar by spring

Axles & suspension:
Drum brake axles, manufacturer’s choice
Laser axle/chassis alignment – reduces tire wear and fuel consumption
Parabolic spring suspension with maintenance-free steel-rubber bushing and mechanical load equalization (rocker equalizer)

Wheels and tires:
235 / 75 R 17.5”
manufacturer’s choice
Steel rims, dual arrangement, factory silver

Brake system:
2-line compressed air braking system
Spring-loaded parking brake
Pjdpjwlmr Djfx Af Njrc
2 fail-safe coupling heads at the front, with connecting lines to the tractor unit, lines extended by approx. 60 cm
Without ABS, but with mechanical ALB; maximum approved speed 60 km/h

Electrics:
12 Volt, multi-chamber lights, no side LED (yellow) lighting, reflectors on side
2 white position lights at front
2 white/red marker lights at rear
1 x 7-pin 12 Volt plug at front, with connection cable, extended by approx. 60 cm
1 LED beacon with holder, switched via sidelights (lamp removable)
2 pairs of warning plates, double LED illuminated and extendable to 3,000 mm

Floor:
Cranked section at front with steel / checker plate covering
Stowage box recessed in the ramp transition near the cranked section
Then with 70 mm softwood flooring, steel / checker plate in the wheel arch area
Rear bevel with 70 mm softwood floor
Low-bed area incl. rear bevel 5,900 mm

Ramps:
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Wood covering (front edge with steel/checker plate)
Hydraulically operated via tractor PTO with throttle, operation LH side compartment
Hydraulic connection with SVK plug NW 10/3, incl. hose

Operating notes:
For 10,000 kg axle load, a special permit is required, only indivisible loads allowed!
The stated total weight is technically possible; depending on the load, it may not be possible to achieve total weight while complying with permissible axle, support, and kingpin loads. (Poor driving and tracking performance possible due to incorrect load distribution)

Country of registration / Signs:
Registration country: Germany
With Dekra inspection and certificate, for max. 60 km/h approval, towing vehicle LoF (agricultural/forestry),
(Switzerland max. 40 km/h approval possible)
Prepared for double-line license plate holder
Without contour marking / reflective tape per ECE R 048

Paintwork:
Frame RAL 7021, black-grey
"10 years warranty against rust-through"
Drawbar hot-dip galvanized
Ramps hot-dip

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.