Polpriklopnik kiper

FLIEGL

Fine-grain steel welded construction with "preload" light pre-tensioning in the neck area, fifth wheel plate with interchangeable 2" kingpin, new version outer frame slightly sloped with "Load-Lock profile" for lashing strap attachment, 24 t two-speed landing gear, single-sided operation, with straight lower section, no draft equalization. Note: Free landing leg corner measurement or free rear swing radius approx. 1930 mm, extendable ladder at the rear. Side door retainers, wheel chocks with holders, side underrun protection in aluminum, underrun protection in galvanized steel, quarter-shell mudguards in front of the 1st axle and behind each axle, anti-spray splash guards behind each axle, rear impact guard, double-sided pallet stops approx. 15–20 mm high, bolted version, loading height reduced by approx. 15–20 mm, plastic toolbox with drawer and shelf, w=650 / h=520 / d=670 mm.

Axles & Suspension
Dujdpfx Agezcmmzjpju
SAF disc brake axles, "Axle/chassis laser alignment" reduces tire wear and fuel consumption, air suspension, 1st axle automatic lift axle including forced lowering and starting aid, axle lift below recommended driving height.

Brake System
2-line compressed air brake system with spring-actuated parking brake, 2 non-interchangeable couplings at the front, without connecting line, EBS electronic braking system with EBS socket at front, without connecting cable. Note: with lift and lower valve, ride height in conjunction with lift axle, when lift axle is raised, load and total height increase by 50 mm.

Wheels and Tires
435/50 R19.5", steel rims.

Electrical System
24 volt, multi-chamber lights, 2 white position lights at front, 2 white/red lane marker lights at rear, 2 x 7-pin and 1 x 15-pin non-interchangeable sockets at front, without connecting cable.

Floor
Anti-slip plywood panels approx. 30 mm thick, on longitudinal beams for high point load capacity, suitable for forklift axle loads up to max. 7100 kg.

Front Bulkhead / Corner Posts
2580 mm high, steel corner posts in high-volume design, release device for side curtain at the front bulkhead.

Intermediate Posts
3 pairs of sliding posts adjustable along the entire length, with 4-fold stake pockets and long pocket at the bottom. 3 pairs of post positions.

Insert Slats
5 rows of aluminum insert slats + Vario slats.

Rear Wall / Rear Corner Posts
Rear corner posts steel up to lower roof edge, curtain attachment with round tube and curtain tensioning ratchet.

Curtain
Curtain with welded-in horizontal and vertical straps, tension locks in stainless steel.

Roof
Fliegl-Blitz sliding roof cover, rear end lift foldable upwards, roof cover can be slid from rear to front, L-roof beam for automotive industry, interior width between roof beams approx. 2,490 mm, curtain color: white (in combination with front sliding roof cover, without front walker).

Country of Approval / Plates
Germany, type approval according to EC 2007/46, 24/7 service hotline, Fliegl manufacturer’s certificate for body strength according to EN 12642 XL, Fliegl manufacturer’s certificate for body strength according to DL 9.5, double-sided pallet stop approx. 20 mm high, loading height reduced by approx. 20 mm, Fliegl manufacturer’s certificate for load securing according to VDI 2700 sheet 12 ff., prepared for single-line license plate holder, warning sign according to ECE-70, reflective stripes: white along the bottom of the side curtain and in the upper corners, reflective stripes: red around rear portal.

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.