Odprta polprikolica s ponjavo

FLIEGL Fliegl SZS 270 Mega Plateau Auflieger

Attention, the images are archive photos! The vehicle may still be in use!

Weights and Dimensions:
Gross vehicle weight: 27,000 kg
Payload approx.: 22,200 kg
Aggregate load: 16,000 kg
Stated fifth wheel load: 11,000 kg
Unladen weight approx.: 4,800 kg +/- build tolerance

Overall length approx.: 13,850 mm
Overall width max.: 2,550 mm
Overall height approx.: 2,245 mm
Platform length approx.: 13,650 mm
Platform width approx.: 2,480 mm
Fifth wheel height approx.: 950 mm
King pin installation dimension approx.: 1,680 mm
Front corner dimension approx.: 2,040 mm

Chassis Semi-trailer for Forwarders
Fine-grain steel welded construction, fifth wheel plate with replaceable 2" king pin
13 pairs of lashing rings recessed in the outer frame, each rated at 2.5 t
Outer frame with “Load-Lock profile” for attaching lashing straps
24 t, 2-speed landing gear, single-sided operation, with straight lower section, without sliding compensation
Wheel chocks with holder
Side underrun protection made of aluminium
Rear underrun protection made of steel
Quarter shell mudguards
Document box on front bulkhead, left side (mounted at a slight angle)

Axles & Suspension
BPW disc brake axles
Air suspension

Braking System
2-line compressed air brake system
Spring-loaded parking brake
2 non-interchangeable coupling heads at front, without connector line
EBS, electronic braking system with EBS socket at the front, without connection cable
Attention: The towed vehicle may only be hauled by tractors which ensure the effectiveness of the ABS!
With lift & lower valve
Vehicle stability system

Wheels and Tyres
385/55 R19.5", make at manufacturer’s discretion
Steel rims, factory silver

Electrics
24 volt, multi-chamber lights (3 sets of old Hella lamps still at factory 2, to be installed if possible), yellow LED side lights installed as far in as possible
2 white position lights at the front, protected by 12 mm round iron crossbars welded above
2 white/red lane marker lights at the rear
2 x 7-pin non-interchangeable sockets at front, without connection cable

Floor
Screen-printed plywood approx. 30 mm thick, transverse joints with Omega insert, mounted on longitudinal bearers for high point load capacity, suitable for forklift axle loads up to max. 7,100 kg
Godpfx Apjy Sk Rqjbsub
Note: Floor warping may occur due to weather exposure!

Front Bulkhead/Corner Posts
Approx. 1,200 mm high, steel corner posts in volume design

Approval / Plates
Country of registration: Germany
With Dekra inspection and certificate
24/7 service hotline
Prepared for single-line number plate holder
Warning panel according to ECE - 70
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear

Paintwork
Frame: RAL 3002 carmine red
Landing legs: black coated
Front wall: RAL 3002 carmine red

Attention, the images are archive photos! The vehicle may still be in use!

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.