Prikolica z nizko platformo

Fliegl VTS 400 Sonder

These images are for reference only!

Gross weight perm. / technical: 24,000 / 40,000 kg
Payload perm. / technical approx.: 14,600 / 30,600 kg
Axle load perm. / technical: 24,000 / 40,000 kg
Unladen weight (base version) approx.: 9,400 kg +/- build tolerance

Overall length approx.: 12,120 mm
Overall width max.: 2,750 mm
Neck length approx.: 2,850 mm
Low loader platform length in driving lane area incl. rear bevel approx.: 7,145 mm
Rear bevel length approx.: 850 mm
Frame width approx.: 2,750 mm
Loading height in the low bed (loaded) approx.: 900 mm
Tow height approx.: 950 mm
Drawbar length approx.: 1,700 mm

Chassis Low Loader Trailer
Steel welded construction
Turntable with heavy-duty ball bearing slewing ring
Foldable rear support
2 wheel chocks with holders
Nkedsyxq A Hopfx Ab Uow
Side underrun protection, aluminium
1 plastic toolbox
Extendable widenings to 3,250 mm (not at rear bevel) (tracking width of transported construction machines or vehicles must not exceed outer frame width of 2,750 mm)
Central storage compartment for wooden planks
70 mm wooden planks for widening to 3,000 mm
2 pairs of stake pockets in the low bed, integrated in the floor longitudinal beams
Lashing rings, low loader:
2 pairs of lashing rings on the neck, each 5 t
1 pair of lashing rings in the rear bevel
4 recessed lashing rings, placed centrally in the floor
2 pairs of key slot profiles in the driving lane, for longitudinal guide rails and as additional lashing points
6 pairs of lashing mushroom anchors in the low bed outer frame, each 10 t
5 pairs of stake pockets in the outer frame of the low bed
4 additional pairs of 10 t lashing rings:
1 on the neck
3 recessed in the floor of the low bed

Drawbar coupling, turntable trailer:
Drawbar with tested 50 mm towing eye

Axles + suspension:
Drum brake axles
Parabolic spring suspension with maintenance-free steel-rubber bearings and mechanical axle load equalization front and rear (rocker leveling)

Wheels and tires:
235 / 75 R 17.5"
Steel rims, twin arrangement, factory silver

Brake system:
2-line air brake system
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front with connection lines for towing vehicle
ABS and ALB, with ABS connector at front, with connection cable
Attention: The towed trailer may only be pulled by towing vehicles that ensure proper function of the ABS!

Floor:
Neck area with steel/chequer plate flooring
then 70 mm softwood floor, wheel recesses with steel/chequer plate flooring
Rear bevel with 70 mm softwood floor

Access ramps:
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Timber surface
Hydraulically operated via tractor PTO

Operating instructions:
For 10,000 kg axle load, a special permit is required, only indivisible loads permitted!!!
Note! Overlength and excess width, special permanent approval required.
For applications for special permits for heavy-duty transport, an axle load display is required for air-suspended vehicles! This applies to all deviations from § 34 StVZO (axle load and permissible gross weight exceedance) that require a special permit under § 70 StVZO.
The declared gross weight is technically feasible; depending on the load, the gross vehicle weight may not be achievable while observing permissible axle, support, and saddle loads. (Poor driving and trailing behavior possible due to incorrect load distribution)

These images are for reference only!

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.