Mini bager

KUBOTA Kompaktbagger KX037-4 MS03 3.+4. Steuerkreis

SN: 209

Kubota Compact Excavator KX037-4 with MS03 Quick Coupler
3rd and 4th auxiliary hydraulic circuits (AUX1/AUX2) with proportional control
Factory-installed load hook on MS03 quick coupler
Dipper arm length: 1,525 mm

Accessories:
1x Digging bucket,
Width: 400 mm,
Mount: MS03 Symlock,
Bucket transport hook,
Full-length cutting edge,

Kubota Crawler Excavator KX037-4 MS03:

Operating weight: approx. 3,695 kg

3rd & 4th auxiliary circuit AUX1/AUX2, proportionally controlled

Load-holding valve for boom cylinder

Load-holding valve for dipper arm cylinder

Factory-installed load hook on MS03 quick coupler

Changeover valve for low-pressure return line for hydraulic breaker

Battery master switch

Dipper arm length 1,525 mm

3-cylinder KUBOTA engine

Rubber tracks

Dozer blade

Radio pre-installation

Sliding front window

Mechanical suspension driver's seat

Dump height: approx. 3,545 mm

Hfjdpfox Tli Dex Adyjf
Digging depth: approx. 3,410 mm

2x halogen work lights on top of cab

1x halogen work light on boom

Standard Equipment:

Engine/Fuel System:
Original KUBOTA engine
Dual air filter element
Acoustic refueling system
Battery disconnect switch
Water separator with drain valve
Auto idle control

Undercarriage:
Short-pitch rubber tracks 300 mm
2 travel speed ranges (fast/slow)
Automatic load-dependent travel speed change
4 externally-guided lower track rollers per undercarriage side
1 upper track roller

Hydraulic System:
2 variable displacement axial piston pumps and 1 gear pump
Emergency lowering via accumulator
Hydraulic measurement connections
Straight travel function
Auxiliary circuits routed to end of dipper arm
Auxiliary circuit (AUX1) with maximum adjustable hydraulic oil flow
Auxiliary circuit AUX1 proportional via right control lever / AUX2 proportional via left control lever – standard for Germany & Austria
Direct tank return line for AUX1 auxiliary circuit

Safety System:
Engine start safety device on left control console
Hydraulic locking system
Upper structure rotation brake
Travel motors with braking system
Original Kubota anti-theft system
Safety/pipe rupture valves for dipper arm and boom (ISO8643)

Working Equipment:
1,525 mm long dipper arm
One work light on boom

Cab:
ROPS (Roll-Over Protective Structure, ISO 3471)
OPG (Operator Protective Guard, Top Guard Level I, ISO 10262)
Cab heater with front window defrost and dehumidifier
Fully suspended driver's seat with adjustable weight (fabric seat)
Retractable seatbelt
2 work lights on cab
Radio installation kit in cab (2 speakers, radio antenna, and radio slot)
Hydraulic pilot control levers with wrist supports
Display unit with diagnostic function
Front window opening system with gas strut support
Mounting points for front window guard
Switch and wiring harness for beacon
12V power supply
Emergency hammer for emergency exit

Technical Data – Dimensions with cab:
Overall width: approx. 1,550 mm
Overall height (cab): approx. 2,470 mm
Overall length: approx. 4,900 mm
Ground clearance: approx. 285 mm
Dozer blade width x height: approx. 1,550 x 340 mm
Rubber track width: approx. 300 mm
Minimum front swing radius without boom swing: approx. 2,100 mm
Minimum front swing radius with boom swing left: approx. 1,730 mm
Boom swing angle (left/right): 69 / 49°

Technical Data – with cab:
Operating weight with cab: approx. 3,695 kg
Operating weight with cab: approx. 3,770 kg
Bucket...

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.