Prikolica z nizko platformo

FLIEGL VTS 400 S Luft/ Hydr. 4-Achs Tieflader -904

New Fliegl 4-Axle Low Loader Trailer with Ramps, Type VTS 400

Gross weight: 24,000 kg / 40,000 kg
Unladen weight: 8,080 kg
Payload: 15,920 kg / 31,920 kg
Overall length: 11,940 mm
Load length: approx. 10,410 mm total, stepped area approx. 2,490 mm, loading bed incl. rear ramp slope approx. 7,920 mm
Width: 2,550 mm
Loading height: 900 mm
Further information
plus pre-carriage / delivery from stock location 26639 Wiesmoor €1,280.00 net

Chassis Low Loader Trailer
Robust steel welded construction
Turntable with heavy-duty ball bearing race
Rear supports, foldable
2 wheel chocks with holders
Aluminium side underrun protection
Full-width rear mudflap
Partial shell fenders on 1st and 2nd axle with anti-spray mudflaps behind each axle
Anti-spray mudflaps before and after 3rd and 4th axle
Excavator arm recess starting from the rear axles towards the end, approx. 1800 mm long, approx. 650 mm wide, approx. 150 mm deep
2 pairs of lashing holes, each rated for 5 t, in the excavator arm recess on the side of the main frame approx. 300 mm from the front and approx. 200 mm before the rear ramp slope
1 plastic toolbox, lockable, dimensions: w=600 mm / h=425 mm / d=460 mm
Recessed stowage box in the floor of the stepped area with cover, W=720 mm/L=520 mm/D=170 mm
Extendable widenings up to 3,000 mm (not at the rear ramp slope)
(Note: Track width of transport machines/vehicles must not exceed outer frame width of 2,550 mm)
Storage compartment for wooden planks beneath the low loader deck
70 mm wood planks for extending to 3,000 mm width
Lashing points Low Loader
1 pair of lashing cut-outs at the front, recessed into the main beam at the stepped area, each rated for 10 t
4 pairs of lashing holes on the outer frame, rated for 5 t each (suitable for lashing straps)
9 pairs of lashing mushrooms, recessed in the top and sides of the outer frame, each rated for 10 t:
2 x front on the stepped area
7 x in the low-bed area
First lashing point 250 mm from the front, last max. 250 mm from the rear; distance between lashing points not more than 1,100 mm
3 additional pairs of folding lashing eyes, each rated for 10 t:
1 x over the stepped area
1 x at the beginning of the low-bed, recessed into the main beams
1 x behind the last axle, recessed in the floor
Drawbar Assembly Turntable Trailer
Drawbar with certified 50 mm towing eye
Drawbar height adjustable via spring
Axles & Suspension
Drum brake axles, manufacturer's choice
Pgedpjxrx Nfofx Af Nsu
Axle/chassis laser alignment for reduced tyre wear and fuel consumption
Air suspension with lift & lower valve, auto-reset function
Wheels and Tyres
235/75 R 17.5”, manufacturer’s choice
Steel twin wheels, plant silver
Brake System
2-line compressed air brake system
Spring-loaded parking brake
Axle load detection via EBS CANbus signal, for display in the truck cab (truck must be equipped, not installed, not a certified weighing system)
Vehicle Stability Control System
2 plug-safe coupling heads at the front with linkage to prime mover
12-24 Volt EBS, electronic braking system with EBS connector in front, incl. cable
Brand: Knorr
Note: The trailer may only be towed by vehicles that can guarantee ABS function!
Electrics
12-24 Volt, multicompartment LED lights, LED side marker lights, LED number plate lighting
(Note: With certain towing vehicles, incorrect diagnostics may occur despite proper function)
2 white front position lights in LED
2 white/red Lane marker rear lights in LED
2 x 7-pin plug-safe connectors in front, incl. cable
1 LED beacon with

Oglas je bil preveden samodejno, zaradi česar je morda prišlo do napak pri prevodu.