Odprta platforma

Fliegl TPS 200 Jumbo Z

Further information
Chassis central axle trailer
Fine-grain steel welded construction
Type TPS 200 (special permit required)
Crank support leg at the front
Foldable rear support
Wheel chocks with holder
Side underrun protection made of aluminum
Full-width mud flaps at the rear
Mud flaps in front of each axle and anti-spray mud flaps behind each axle
1x spare wheel holder for 1 E-tyre, with wheel fixing kit
1x spare wheel, same brand as main tyres, steel rim
1x stainless steel storage box, width=600/height=400/depth=500 mm, with polished lockable door
Lashing points for low loader
Csdpfxsp N Dgus Al Hsgt
5 pairs of stake pockets embedded in the outer frame, inside dimensions 70 x 40 mm (can be retrofitted with 5t lashing rings, not included)
7 pairs of lashing mushrooms recessed into the top and side of the outer frame, each 10 tonnes
2 pairs of fold-down lashing eyes additionally recessed into the low bed platform, each 10 tonnes (1 pair at the front and 1 pair on the rear slope)
Towing device central axle trailer
Drawbar with certified 50 mm drawbar eye
Axles + Suspension
SAF drum brake axles
Laser-measured axles/chassis to reduce tyre wear and fuel consumption
Axle spacing 1810 mm (then 10 tonne technical axle load)
Air suspension
Brake system
2-line compressed air brake system, color-coded air line layout for easy maintenance.
Spring-loaded parking brake
Duomatic coupling at the front, with connecting line to towing vehicle,
EBS, Electronic Braking System with EBS connector at the front, with connection cable
Note: This trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
with lift & lower valve
Vehicle - Driving stability system
Axle load detection via EBS Canbus signal, for display on the dashboard display, truck must be suitably pre-equipped, no truck installation (not a certified scale)
Wheels and Tyres
235/75 R17.5 Brand Fulda
Steel rims, factory silver
Electrics
24 volt, multi-chamber lights, side yellow LED lighting
2 white position lights at the front
2 white/red lane marker lights at the rear
1 x 15-pin connector at the front, with connection cable
1 additional LED work light at the rear, switched via reversing light
1x LED beacon with holder, switched via side light (lamp removable)
Flooring
subsequently with 70 mm softwood flooring, wheel arch area with steel/chequer plate covering
Rear beavertail with Mega Grip serrated grating coating
Low-bed platform incl. rear beavertail 6500 mm
Front wall / corner stanchions
25 mm aluminium hollow section, 400 mm high, removable
Loading ramps
Steel ramps 3600 mm long, 750 mm wide, split with cable tension, laterally adjustable
Ramp traverse, minimum gap approx. 600 mm, maximum outer width approx. 2880 mm
Ramp surface with Mega Grip serrated grating
Operated hydraulically via own electro-hydraulic unit, mounted in a steel box, operation on the right side at the front. Note: NATO socket with connecting cable on the truck required. Cable must not be connected during driving!
Hydraulic lateral adjustment of loading ramps, individually controllable (only in combination with hydraulic ramp actuation)

Oglas je bil avtomatsko preveden. Možne so napake pri prevodu.